Dsc-hx300 firmware update
2018年8月19日 日常Dsc-hx300 firmware update
※ Download: https://bit.ly/2L5Oizq
Thank you for your continued interest in Sony products. Note: The upgrade can be performed only when the remaining battery level is three marks or more. We recommend that you use a fully charged battery. Please save the downloaded file onto the Desktop of your computer recommended. Click the Desktop tile from the Start screen and find the downloaded file in the Downloads folder by using Explorer. Note: When the camera is connected to the computer, the LCD monitor of the camera turns off. Please proceed to the next step. Try the following if this happens. Your computer may have some USB terminals on the backside. The screen below appears on Firmware Updater. The current version and the version after the upgrade appear on the lower left part of the screen. Upgrade is required If the screen below appears, the upgrade is not required. According to the message, stop the USB connection and click Finish. Turn off the camera, remove the battery pack, reinsert the battery pack, and then turn on the camera again. Notes: - Please keep the USB cable connected even after stopping the USB connection on the computer with the above operation. Note: The screen turns off when the center of the control wheel is pressed. Please proceed to the next step. The progress bar appears while upgrading approximately 15 minutes. Note: Never turn off the camera nor disconnect the USB cable while upgrading. Make sure the camera is turned ON and wait until the LCD screen appears again. Click Finish when the LCD screen appears and disconnect the USB cable.
※ Download: https://bit.ly/2L5Oizq
Thank you for your continued interest in Sony products. Note: The upgrade can be performed only when the remaining battery level is three marks or more. We recommend that you use a fully charged battery. Please save the downloaded file onto the Desktop of your computer recommended. Click the Desktop tile from the Start screen and find the downloaded file in the Downloads folder by using Explorer. Note: When the camera is connected to the computer, the LCD monitor of the camera turns off. Please proceed to the next step. Try the following if this happens. Your computer may have some USB terminals on the backside. The screen below appears on Firmware Updater. The current version and the version after the upgrade appear on the lower left part of the screen. Upgrade is required If the screen below appears, the upgrade is not required. According to the message, stop the USB connection and click Finish. Turn off the camera, remove the battery pack, reinsert the battery pack, and then turn on the camera again. Notes: - Please keep the USB cable connected even after stopping the USB connection on the computer with the above operation. Note: The screen turns off when the center of the control wheel is pressed. Please proceed to the next step. The progress bar appears while upgrading approximately 15 minutes. Note: Never turn off the camera nor disconnect the USB cable while upgrading. Make sure the camera is turned ON and wait until the LCD screen appears again. Click Finish when the LCD screen appears and disconnect the USB cable.
コメント